Heat Recovery Ventilator (HRV)

General Maintenance 

First, start by opening the access door to your HRV. Grip the ends of the core – it may be snug – and pull evenly outward. Gently slide the filters out.

Next, rinse the filters with cold water. If they’re really dirty, give them a gentle vacuum first and then soak using a mild detergent and warm water. Gently shake the filters to remove the excess water, allowing them to air dry. Don’t clean with hot water, the dishwasher or wring them out, as this may cause damage. 

Reinstall your clean HRV filters in place against the core, and gently slide the core back into its original position. 

Alberta New Home Warranty recommends cleaning your HRV filters every three months.

Using the Panel

Learn how to use the fantech wall-mounted control panel for your new home. This control panel is normally located on the main floor by your thermostat.